Control Unit + LCD8YN Display + Pas + Universal Wiring Kit 48V 22A UPG Brushless Motors

Universal kit consisting of:

- 48V UPG control unit
- 24/36 / 48V Lcd8S UPG Multifunction color display
- Pedal Assisted Pas sensor
- 1T4 wiring harness for display-brakes-accelerator - UPG

NB: This kit can only be assembled complete with all its components and only and exclusively on brushless motors (brushless motors with 3 large wires plus 5/6 small ones at the motor output).

Technical specifications:

48 Volt 22A control unit - with and without hall sensors - UPG
- This universal control unit works at 48v and also has the particularity of being able to work both with motors with hall sensors (the 5/6 small wires coming out of the motor) and with motors that are not equipped with hall sensors.
- This universal control unit works with all brushless motors (without brushes) but hardly interfaces with the standard bike displays.
- It can be mounted on: E-Bikes, electric scooters, electric scooters, electric quads, scooters for the disabled. So on every electric vehicle that has a brushless motor (you can guess if the motor is brushless from the exit of three yellow, green and blue wires from the motor).
- We also recommend purchasing our universal display to make sure your controller works properly.
Measures:
LENGTH: 9.7cm
TOTAL LENGTH: 10.5cm
WIDTH: 6cm
HEIGHT: 3.5cm

Technical data:
MODEL: KT48ZWSRTD-PXS24L
RATED VOLTAGE: DC48V
RATED CURRENT: 11A
MAXIMUM CURRENT: 22 +- 1A
LOW VOLTAGE PROTECTION: DC40+ - 0.5V
SPEED SET: 1-4.2V

KT LCD8YN model color display compatible with KT control units.
This display is only and exclusively compatible with KT (Kunteng) controllers

It has the ability to operate at three different voltages in fact, it can work at both 24v, 36v and 48v.

By purchasing this display it is necessary to verify that the other components are from KT (Kunteng). If not, you can buy all the components on our site.

Technical data:
5/9 assistance levels
Full speed
Average speed
Instantaneous speed
Total km
Partial km
Engine usage time
Turning on the display lights
6 km/h function
Battery level info
Brake lever sensor indicator
Display backlight
Possibility of accessing the menu for other settings such as: speed limitation, speed release, etc.

PAS Sensor Pedal Assist KT-V12L with UPG connection
This pedaling sensor (PAS) is mounted on the left side of the bike.
To install it, the crank arm must be disassembled and then reassembled by tightening the PAS firmly on the axis of the bottom bracket

1T4 wiring harness for display-brakes-accelerator - UPG
- Length 133cm
UPG bindings for:
- Brakes (Red)
- Throttle (Yellow)
- Display (Green)
MEASUREMENTS: Length: 133cm

For any technical information on assembly and compatibility, the technicians are available on 3206140014 also with a whatsapp message. Capobranco Project is not responsible for tampering or incorrect installations. On the control units for electric bikes, scooters and electric scooters, Capobranco Project guarantees a 1-year warranty. Our products are stored and shipped from our headquarters in Italy.